Thermoforming

KMS600

MEAF's KMS600 is our largest thermoforming machine, with an output up to 70.000 cups p/hour!

Show details

BMS700

MEAF's BMS700 is our medium thermoforming machine, with an output up to 25.000 cups p/hour!

Show details

CM420

MEAF's CM420 is our smaller to medium thermoforming machine, with an output up to 15.000 cups p/hour!

Show details

PM420

The in-house developed Punching unit, for accurate punching, stacking and counting of the thermoformed products!

Show details

BMS500

MEAF's BMS500 is our entry-level thermoforming machine, with an output up to 7.500 cups p/hour!

Show details

Thermosol

All delivered thermoforming machines (excluding the BMS500) are delivered with MEAF's developed control system Thermosol. This system encompasses all the required data, functions and recipes into one single system. Thermosol is controlled by means of a touchscreen and can be set for different levels of acces. The combination of the control system with the SpeedAdjust handwheel gives the operator ...

Show details

The process

During the process of thermoforming of plastics, a flat thermoplastic sheet is heated and formed into the desired shape by means of a mould. Thermoforming consists of two main steps: heating and forming.

During the heating process, the material is moved by the transport chain bar, which is adjustable, and moves under the heating elements. Special formation of these elements improves the functioning and usefulness of the heating elements. The heating of the sheet is done to ensure sufficient penetration of heat into the sheet in order to ensure that the sheet is soft enough to be pushed in the mould. The heating time depends on chosen raw material, thickness of the sheet, etc.

After the heating, the sheet is transported between the open mould. The mould closes until the sheet is clamped by cutting half of the sheet thickness. The plug stretches the material into the cavity of the mould and compressed air pushes the sheet equally against the mould. The special design of the plug head and adjustable depth allows adjustments to obtain an even material wall thickness. The choice of plug material(s), such as polyamides, syntactic foam, aluminium, etc., and shapes are designed to suit the final article design.

Moulds for forming and cutting in the mould for processing are offered in a wide range of thermoplastics, including PP, PS, PVC, APET but also PLA and other biomaterials. Single, double and even triple or four row mould are possible on MEAF's machines. Modern technique allows easy & fast changes of mould inserts for side and bottoms.

After cooling the product, the mould closes the last 2 mm and performs the cutting of the product from the web. After this process the mould opens and the products are pushed/blown out of the mould into a stacker. During this process new, heated sheet has been transported between the mould to repeat the cycle.

Contact us

Meaf Machines B.V.

Industrieweg 10
4401 LB Yerseke
The Netherlands

Tel.
: +31 (113) 57 14 95
Fax
: +31 (113) 57 12 56
E-mail
: office@meaf.com

Show map